![]() The UltiMaker S7 is built on the success of the UltiMaker S5 and its design decisions were heavily based on feedback from customers. I mentioned this to the recent Community event when we had the software discussions on the Friday afternoon. This is part of a Design for Additive Manufacturing (DfAM) workflow that I teach as part of my Fusion 360 training activities. It's not unusual for me to do three or four repeats of this to get to a final design for 3D printing, and opening a new Cura session each time makes this less efficient. When is this a problem? When I'm optimising a design for 3D printing I check the layer stack in Cura, then go back into Fusion 360 and make modifications to make difficult areas easier to print, and then repeat the layer stack check. ![]() This adds time to the process because you have to wait for Cura to open up again. ![]() With latest Cura each time I send a model to 3D print it opens up a brand new session even if there's one already open. After that if Cura was left open and further transfers were made it inserted the model into the same session. What I mean specifically is that with 15.04 once I'd chosen to 3D print a part from Fusion 360 and automatically sent it to Cura it would open a new session if Cura wasn't already open. Would it be possible to change the Cura software in the way it interacts with Autodesk's Fusion 360 to the same way it did with 15.04?
0 Comments
Leave a Reply. |